Fanuc

nth-axis (n=1-8) APC framing error. Failure in data transmission. Possible causes include a faulty APC, cable, or servo interface module.

nth-axis (n=1-8) APC overtime error. Failure in data transmission. Possible causes include a faulty APC, cable, or servo interface module.

nth-axis (n=1-8) APC communication error. Failure in data transmission Possible causes include a faulty APC, cable, or servo interface module.

Manual reference position return is required for the nth-axis (n=1-8).

Alarm details Binary input operation using high-speed remote buffer (G05) or high-speed cycle machining (G05) has been specified in advance control mode (G08P1). Execute G08P0; to cancel advance control mode, before executing these G05 commands.

An excessive error arose during spindle positioning for ATC. For details, refer to diagnosis No. 531. (Only for DRILL-MATE)

This alarm is issued in the following cases (DRILL-MATE): An M06T_ command contains an unusable T code. An M06 command has been specified when the Z machine coordinate is positive. The parameter for the current tool number (No. 7810) is set to 0. An M06 command has been specified in canned cycle mode. A reference position return command (G27 to G44) and M06 command have been specified in the same block. An M06 command has been specified in tool compensation mode (G41 to G44). An M06 command has been specified without performing reference position return after power-on or the release of emergency stop. The machine lock signal or Z-axis ignore signal has been turned on during tool exchange. A pry alarm has been detected during tool exchange. Refer to diagnosis No. 530 to determine the cause.

A value for the Z-axis has been specified in a block for the tool exchange command (M06T_) on a system with DRILL-MATE ARC installed. A tool change (M06) and a Z-axis movement were specified simultaneously
in the DRILL MATE. Correct the program.

When an encrypted program is output, EIA is set for the punch code. Specify ISO.

During read of an encrypted program, an attempt was made to store the program with a number exceeding the protection range. (See parameter Nos. 3222 and 223.)