Fanuc

Conditions when performing circular interpolation start or cancel not correct. To change the mode to the cylindrical interpolation mode, specify the command in a different format. Modify the program.

Incorrect tool figure data in interference check. Set correct data, or select correct tool figure data.

G68 and G69 are not independently commanded in balance cut. Modify the program.

A subprogram which performs parallel copy with G72.2 contains another G72.2 command.

Different M code is commanded in heads 1 and 2 as waiting M code. Modify the program. A subprogram which performs rotational copy with G72.1 contains another G72.1 command.

During executing a life data setting program, power was turned off. Reset again.

The tool life to be set is too excessive. Modify the setting value.

The number of tool groups to be set exceeds the maximum allowable value. (See parameter No. 6800 bit 0 and 1) Modify the program.

P and L commands are missing at the head of program in which the tool group is set. Correct the program.

In the machining program, M06 and T code in the same block do not correspond to the group in use. Correct the program. Group No.** which is specified with T** 88 of the machining program do not included in the tool group in use. Correct the program.