Fanuc alarm: 154 - NOT USING TOOL IN LIFE GROUP
When the group is not commanded, H99 or D99 was commanded. Correct the program.
None currently
When the group is not commanded, H99 or D99 was commanded. Correct the program.
None currently
In tool life data registration, a T code was not specified where one should be. Correct the program.
None currently
The number of tools within one group exceeds the maximum value registerable. Modify the number of tools.
None currently
The tool group commanded in the machining program is not set. Modify the value of program or parameter.
None currently
Tool Group No. exceeds the maximum allowable value. Modify the program.
None currently
A code other than Q1,Q2,P1 or P2 was specified as the life count type in the extended tool life management.
None currently
Automatic corner override deceleration rate is out of the settable range of judgment angle. Modify the parameters (No.1710 to No.1714)
None currently
G codes which cannot be specified in the polar coordinate interpolation mode was specified. See section II-4.4 and modify the program.
None currently
The conditions are incorrect when the polar coordinate interpolation starts or it is canceled. 1) In modes other than G40, G12.1/G13.1 was specified. 2) An error is found in the plane selection. Parameters No. 5460 and No. 5461 are incorrectly specified. Modify the value of program or parameter.
None currently
The coordinate rotation plane and arc or cutter compensation C plane must be the same. Modify the program.
None currently
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer