160i/180i/210i

CNC Description: When bit 2 of parameter No. 5400 is set to 1, and a reset does not cancel G68, this alarm is issued at the time of program restart. To release this alarm, press <RESET> and <CAN>. Once this operation is performed, the alarm will not be issued at the next restart.
Fanuc alarm: 5453 - NOTE: G68 IS CANCELED (HPCC)(M series)

CNC Description: A permissible acceleration parameter for optimum torque acceleration/ deceleration is incorrect. The cause is one of the following: 1) The ratio of the deceleration rate to the acceleration rate is below the limit. 2) The time required for deceleration to a speed of 0 exceeds the maximum value.
Fanuc alarm: 5455 - ILLEGAL ACC. PARAMETER(M series)

CNC Description: The interference check evade function of cutter compensation determines that an evade operation will lead to danger.
Fanuc alarm: 5447 - CRC:DANGEROUS AVOIDANCE(M series)

CNC Description: In the interference check evade function of cutter compensation, a further interference occurs for an already created interference evade vector.
Fanuc alarm: 5448 - CRC:INTERFERENCE TO AVD.(M series)

CNC Description: A G code that cannot be specified is found. (5-axis mode) This alarm is issued when: 1) Three-dimensional cutter compensation (side-face offset and leading- edge offset) is applied during cutter compensation, or cutter compensation is applied during three-dimensional cutter compensation (side-face offset and leading-edge offset). 2) A leading-edge offset of three-dimensional cutter compensation is applied during side-face offsetting of three-dimensional cutter compensation, or a side-face offset of three-dimensional cutter compensation is applied during leading-edge offsetting of three-dimensional cutter compensation. 3) Tool axis direction tool length compensation is applied during tool length compensation, or tool length compensation is applied during tool axis direction tool length compensation. 4) Tool center point control is provided during tool length compensation, or tool length compensation is applied during tool center point control. 5) Tool center point control is provided during tool axis direction tool length compensation, or tool axis direction tool length compensation is applied during tool center point control. If this alarm is issued, cancel the relevant mode, then specify a different mode.
Fanuc alarm: 5452 - IMPROPER G-CODE (5AXIS MODE)(M series)

CNC Description: Incorrect parameter setting (setting of the rotation axis)
Fanuc alarm: 5436 - PARAMETER SETTING ERROR 1(TLAC) (M series)

CNC Description: Incorrect parameter setting (setting of the tool axis)
Fanuc alarm: 5437 - PARAMETER SETTING ERROR 2(TLAC) (M series)

CNC Description: The drilling axis specified for the drilling canned cycle is incorrect. The G code command block of the canned cycle does not specify the Z point of the drilling axis. When there is a parallel axis with the drilling axis, the parallel axis is also specified at the same time.
Fanuc alarm: 5440 - ILLEGAL DRILLING AXISSELECTED (M series)

CNC Description: Corner circular interpolation (G39) of cutter compensation is not specified alone but is specified with a move command.
Fanuc alarm: 5445 - CRC:MOTION IN G39 (M series)

CNC Description: Because there is no interference evade vector, the interference check evade function of cutter compensation cannot evade interference.
Fanuc alarm: 5446 - CRC:NO AVOIDANCE (M series)