Fanuc alarm: 29 - ILLEGAL OFFSET VALUE
The offset values specified by T code is too large or the offset values specified by H code is too large.
None currently
- Read more about Fanuc alarm: 29 - ILLEGAL OFFSET VALUE
- Log in to post comments
The offset values specified by T code is too large or the offset values specified by H code is too large.
None currently
In the plane selection command, two or more axes in the same direction are commanded. Modify the program.
None currently
No axis is specified in G43 and G44 blocks for the tool length offset type C.Offset is not canceled but another axis is offset for the tool length offset type C. Modify the program.
None currently
F0 (fast feed) was instructed by F1 -digit column feed in circular interpolation. Modify the program.
None currently
In circular interpolation by radius designation, negative value was commanded for address R. Modify the program.
None currently
The command for circular interpolation lacks arc radius R or coordinate I, J, or K of the distance between the start point to the center of the arc.
None currently
An axis not included in the selected plane (by using G17, G18, G19) was commanded in circular interpolation. Modify the program.
None currently
In circular interpolation (G02 or G03), difference of the distance between the start point and the center of an arc and that between the end point and the center of the arc exceeded the value specified in parameter No. 3410
None currently
An attempt has been made to move the tool along more than the maximum number of simultaneously controlled axes. Alternatively, no axis movement command or an axis movement command for two or more axes has been specified in the block containing the command for skip using the torque limit signal (G31 P99/98). The command must be accompanied with an axis movement command for a single axis, in the same block.
None currently
A synchronous feed is specified without the option for threading / synchronous feed. In variable lead threading, the lead incremental and decremental outputted by address K exceed the maximum command value or a command such that the lead becomes a negative value is given. Modify the program. An attempt was made to move the machine along the axes, but the number of the axes exceeded the specified number of axes controlled simultaneously. Modify the program.
None currently
Theme by Danetsoft and Danang Probo Sayekti inspired by Maksimer