Fanuc alarm: 37 - CAN NOT CHANGE PLANE IN CRC / CAN NOT CHANGE PLANE IN NRC
37 - CAN NOT CHANGE PLANE IN CRC / CAN NOT CHANGE PLANE IN NRC
Fanuc's Alarm Description: G40 is commanded on the plane other than offset plane in cutter compensation B. The plane selected by using G17, G18 or G19 is changed in cutter compensation C mode. Modify the program. The offset plane is switched in tool nose radius compensation. Modify the program. The offset plane is switched in tool nose radius compensation. Modify the program.
Additional Suggestions & Alarm Clarification:
None currently
Help Others:
Post troubleshooting recommendations for (Fanuc alarm: 37 - CAN NOT CHANGE PLANE IN CRC / CAN NOT CHANGE PLANE IN NRC ) error message below.
Fanuc CNC Control Models Applicable:
16/18/21, 16i/18i/21i, 160i/180i/210i, 0/00/0-mate, 0i
Manufacturing | Industrial | CNC machinist | Maintenance | Repair
